Sealey LED183 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Keep away
instruction
from rain
manual
1. safety
Do not use if the lantern appears damaged in any way.
8
Do not charge using any other cable than that supplied with the product.
8
Do not subject to wet or damp conditions
8
2. introDuction
Composite case lantern with hanging/carry handle. Operates 10 SMD LEDs that feature three selectable light settings producing up to 360
lumens of warm white light. Built-in speaker with wireless connectivity can be used with light on or off, providing up to 10 hours of playback.
Powered by a 3.7V 2.6Ah Lithium-ion battery. Supplied with USB charging cable.
3. sPecification
Model no: ........................................................................ LeD183
Lumen Output: ............................... High/Med/Low - 360/150/18lm
Operating Time: ...................................High/Med/Low - 2.5/8/65hr
LED Qty: ...........................................................................10 SMD
IP Rating: ...............................................................................IPX4
Battery: ..................................................... 3.7V 2.6Ah Lithium-ion
4. oPeration
4.1. charging
4.1.1. Connect the micro USB plug to the charging socket located beneath the rubber flap.
4.1.2. Connect the other end of the charging cable to a 5V USB outlet.
4.1.3. When charging commences, the switch shows a red aspect.
4.1.4. When the charge is complete, the aspect changes to green. At this point, disconnect the USB lead.
4.2. Lamp operation
4.2.1. Press the switch successive times for: high, medium, low and off.
4.3. Wireless speaker operation
4.3.1. Press the switch for 5 seconds to activate the wireless connection.
4.3.2. The speaker will emit a chime and the switch will display a flashing blue signal to show that it is searching for a pairing.
4.3.3. A second chime and a solid blue signal denotes a successful pairing (the identity of the lantern on the input device will show as
'SEALEY').
4.3.4. A further 5 second press will switch the wireless function off.
© Jack Sealey Limited
INSTRUCTIONS FOR:
recHarGeaBLe Lantern 10sMD LeD with
WireLess sPeaKer
LeD183
MODEL NO:
Original Language Version LED183 Issue:1 - 21/12/17