Recording; Basic Recording - JVC GR-AX910U Instructions Manual

16
POWER
Start/Stop
The power indicator
25min
Tape remaining time indicator
120min 119min
1min (Blinking) 2min (Blinking)
0min (Blinking)
* min.....(Now calculating)
NOTES:
A cassette holder can't be opened unless a power supply is attached.
There may be a delay after you slide EJECT until the holder opens. Do not use force.
The tape's remaining time is displayed in the viewfinder as shown.
The indicated remaining time is approximate.
The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary
according to the type of tape used.
The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been
selected ( pg. 12).
"TAPE END" appears when the tape reaches its end, and the power goes off automatically if left in this
condition for 5 minutes. "TAPE END" also appears when a cassette whose tape is already at its end is
loaded.
If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations,
the camcorder's power shuts off automatically. Set the Power switch to "POWER OFF", and then back to
"CAMERA" to turn the camcorder on again.
If you're recording on a cassette from the middle, use the Retake function (
last recording so you don't erase any of it.
The LENS COVER warning blinks for about 8 seconds when the camcorder is turned on, when the cover is
closed.
NOTE:
LENS COVER
You should already have performed the procedures listed
SWITCH
below. If not, do so before continuing.
Power (
Tape Length (
Recording Mode Setting (
Grip Adjustment (
LOAD A CASSETTE
1
Slide EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
ENTER RECORD–STANDBY MODE
2
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
"CAMERA".
•The power indicator lights and the camcorder
•The scene you're aimed at appears on the
START SHOOTING
3
Press the RECORDING START/STOP button.
Tally lamp
•The tally lamp lights while recording is in progress,
•If you want to turn the tally lamp off, see page 31.
STOP RECORDING
4
Press the RECORDING START/STOP button again to
3min
stop recording.
•The camcorder re-enters the Record-Standby

RECORDING

pg. 8)
pg. 12)
pg. 13)
pg. 14)
enters the Record–Standby Mode.
viewfinder screen, with the word "PAUSE"
superimposed upon it.
REC
and " " appears in the viewfinder.
mode.
pg. 18) to find the end of the

Basic Recording