Removing a Hot-Swap Drive Carrier from the Chassis
1. Press the release button on the drive carrier, which will extend the drive carrier handle.
2. Use the drive carrier handle to pull the drive out of the chassis.
Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier, by removing
the screws securing the dummy drive to the carrier. These screws are not used to
mount the actual drive.
Figure 3-6. Removing the Dummy Drive from a Carrier
Chapter 3: Maintenance and Component Installation
2
1
Figure 3-5. Removing a Drive Carrier
49
Dummy Drive
Hard Drive
Carrier