Replacing Fuse - Dyna-Glo RMC-KFA45DGP-01 User's Manual And Operating Instructions

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!

10. REPLACING FUSE

NOTICE : This heater is fuse protected.
If your heater fails to ignite, DO NOT RETURN YOUR HEATER TO THE
STORE.
Please follow the simple instruction below to inspect and change the fuse.
PROCEDURE FOR REPLACING FUSE
WARNING : SHOCK HAZARD
To prevent personal injury, unplug the power cord before replacing fuse.
1. Unplug heater.
2. Remove side cover screws using medium phillips screw driver.
3. Disconnect switch wires from power switch.
4. Remove fuse from fuse holder.(See Figure 24.)
5. Replace fuse with enclosed fuse.
WARNING : FIRE HAZARD
To avoid fire, Do not substitute with a higher or lower current rating.
6. Replace switch wires to power switch.
7. Replace side cover.
NOTE : Specified fuse rating : AC 125/8A
Screw
Side Cover
Power Switch
Switch Wire
Fuse Holder
Figure 24. Replacing Fuse
14
Fuse Holder
Fuse
RMC-KFA75/125TDGP-01/210TDGP-02 Models
Fuse
RMC-KFA45DGP-01 Model