Installing The Remote - JBL BASSPRO Owner's Manual

INSTALLING THE REMOTE

The Subwoofer Level Control may be Choose a mounting location that allows
mounted under the dash or dismantled easy access to the control, and
and mounted in the dash for a factory- provides 1-3/4" clearance behind the
installed appearance. mounting surface. Drill a 9/32" hole in
the mounting surface. Feed the
Subwoofer Level Control's potentiome-
UNDER-DASH MOUNTING
ter shaft (with the knob removed)
Select a mounting location that allows
through the hole and use the nut and
easy access to the control while driving.
washer provided to hold the control in
Using the Subwoofer Level Control as a place (Figure 5).
template, mark and drill holes in the
mounting surface. Attach the
Subwoofer Level Control using the
mounting screws provided (Figure 4).
IN-DASH MOUNTING
Disassemble the Subwoofer Level
Control by removing the two Phillips-
head screws on the front panel,
rear panel and on top. Remove the
Subwoofer Level Control's bottom and
side panels. Slide the Subwoofer Level
Control's PC board forward to release
the RJ11 connector from the back panel
and remove the board along with the
potentiometer, knob and connector as a
single assembly.
Figure 4. Under-dash mounting of the
Subwoofer Level Control.
CONNECTING THE SUBWOOFER
LEVEL CONTROL TO BASSPRO
Route the cable behind the dash or
other interior panels and under the
carpet. Do not route the cable outside
the vehicle. Connect the RJ11 cable
between the RJ11 receptacle on the
BassPro and the receptacle on the
Subwoofer Level Control (Figure 6).
Level-
Washer
Control
Circuit
Board
Hex Nut
Knob
Figure 5. In-dash mounting of the
Subwoofer Level Control.
BassPro Connection Panel
Control
Cable
Socket
for
Control
Cable
Rear View of
Level-Control
Circuit Board
Figure 6. Subwoofer Level Control
electrical connection.
3