ENGLISH
EN
8.5 Disassembling of the thermostatic mixing valve
1. Disconnect the power supply and secure it against being
switched on again.
2. Remove the front panel of the pump group (A, fig. 1).
3. Close all stop valves by turning the thermometer handle
(B, fig. 1).
4. Disassemble thermometer handles and intermediate insu-
lation (C, fig. 1).
5. Dismantle the thermostatic mixing valve with temperature
setting (D, fig. 3) by loosening the union nuts (X, fig. 3).
8.6 Installation of the thermostatic mixing valve
1. Replace damaged or defective seals if necessary.
2. Insert the thermostatic mixing valve (D, fig. 3) and tighten
the nuts (X, fig. 3) (for tightening torques see "Technical
data" on page 4).
3. Slowly open the ball valves by turning the thermometer
handle (B, fig. 1).
4. Restore the power supply to the pump group.
5. Disassemble the thermometer handles (B, fig. 1).
6. Install the intermediate insulation, the thermometer han-
dles, and the front panel.
HKF20-IM-DE-W-UK-11-2020-Rev.0.1 | Part no. 10084531
3
X
X
D
11