Installing The I/O Board - Dell Inspiron 16 5625 Service Manual

Hide thumbs Also See for Inspiron 16 5625:
Table of Contents

Advertisement

4. Disconnect the I/O board cable from the I/O board.
5. Disconnect the coin-cell battery cable from the I/O board.
6. Lift the fingerprint-reader cable connector latch and disconnect the optional fingerprint-reader cable from the I/O board.
7. Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
8. Lift the I/O board off the palm-rest and keyboard assembly.

Installing the I/O board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the I/O board with the screw holes on the system board and palm-rest and keyboard assembly.
2. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
3. Place the I/O board on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O board cable to the I/O board.
6. Close the latch and replace the clear adhesive tape.
7. Connect the coin-cell battery cable to the I/O board.
8. Connect the optional fingerprint-reader cable to the I/O board and close the latch to secure the cable.
9. Close the right-display hinge.
10. Replace the two screws (M2.5x5) that secure the right-display hinge of the display assembly to the system board.
Next steps
1. Install the
3-cell battery
or
4-cell
battery, whichever is applicable.
Removing and installing components
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

P117f

Table of Contents