Table of Contents
Advertisement
Steps
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Adhere the tape that secures the power-adapter port cable to the system board.
3. Connect the power-adapter port cable to the system board.
4. Adhere the tape that covers the power-adapter port connector on the system board.
5. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x5) that secures the left display hinge to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
memory
module.
4. Remove the
M.2 2230 solid-state drive
5. Remove the
wireless
card.
6. Remove the
3-cell battery
7. Remove the
display
assembly.
8. Remove the fan.
9. Remove the
coin-cell
10. Remove the
I/O
board.
11. Remove the
power
button.
12. Remove the
power-button
13. Remove the
power-adapter
After working inside your
Before working inside your
or
M.2 2280 solid-state
or
4-cell
battery, whichever is applicable.
battery.
board.
port.
computer.
computer.
drive, whichever is applicable.
Removing and installing components
55
Advertisement
Table of Contents
