Physical Characteristics; Safety Voltages - National Instruments NI-9146 Safety, Environmental, And Regulatory Information

the resulting total power consumption is a maximum value and that the
NI 9146 may require less power in your application. For more information
about the I/O module power requirements, refer to the module operating
instructions.

Physical Characteristics

If you need to clean the NI 9146, wipe it with a dry towel.
Tip
For two-dimensional drawings and three-dimensional models of the
NI 9146, visit
Weight (unloaded)
Screw-terminal wiring
Gauge
Wire strip length
Temperature rating
Torque for screw terminals 0.20 N · m to 0.25 N · m (1.8 lb · in. to 2.2 lb · in.)
Wires per screw terminal
Connector securement
Securement type
Torque for screw flanges

Safety Voltages

Connect only voltages that are within the following limits:
V terminal to C terminal
Measurement Category I is for measurements performed on circuits not directly
connected to the electrical distribution system referred to as MAINS voltage. MAINS
is a hazardous live electrical supply system that powers equipment. This category is
NI-9146 Safety, Environmental, and Regulatory Information
ni.com/dimensions
2
0.2 mm to 2.1 mm
6 mm (0.24 in.) of insulation stripped from the end
85 °C
One wire per screw terminal
Screw flanges provided
0.3 N · m to 0.4 N · m (2.7 lb · in. to 3.5 lb · in.)
30 V maximum, Measurement Category I
and search by module number.
643 g (22.7 oz)
2
(24 AWG to 14 AWG) copper conductor wire
© National Instruments
23