Rear Panel Connections - JBL DSC 500 Owner's Manual

R E A R P A N E L C O N N E C T I O N S
Refer to the pages indicated in
parentheses for details.
AM Antenna (page 13). Connect to
the supplied AM loop antenna.
FM Antenna (page 13). Connect to
the supplied FM antenna.
Audio Out (page 14). Optional
connection to a TV set or external
audio system (also for recording
devices). Not necessary when using
DSC loudspeaker system and
subwoofer connection.
AUX 1/AUX 2 Audio In (page 14).
Connect to a line-level analog audio
source: TV, tape player, Minidisc, PC,
etc.
6
SCART In/Out (page 14). Connect
to a TV SCART input. (SCART cable
included.)
Video Out (page 14). Connect to a
TV video input. (Composite video
cable not included).
S-Video Out (page 14). Connect to
a TV S-Video input. (S-Video cable
not included).
System Audio Output (page 12).
Connect to "System Audio Input" on
the DSC active subwoofer.
AC Power Cord (page 14).
Connect to a 230V wall outlet.
Coaxial Digital Input: Connect the
coax digital output from a DVD player,
HDTV receiver, LD player, MD player
or CD player to this jack. The signal
may be either a Dolby Digital signal,
DTS signal or a standard PCM digital
source. Do not connect the RF digital
output of an LD player to these jacks.
Main Power Switch: Press this
button to apply power to the DSC 500.
When the switch is in the "1" position,
the unit is placed in Standby mode, as
indicated by the blue LED on the front
panel. To turn the unit off completely
and prevent the use of the remote
control, this switch should be set to
the "0" position.