Mounting The Deflector; Mounting The Cutting Attachment - Stihl FS-MM Instruction Manual

7 Mounting the Deflector

3
► Push the gearbox (3) into position and tighten
down the clamp screws (4).
► Tighten the two clamp screws on the gearbox
in the following sequence:
– Tighten the first screw moderately.
– Tighten the second screw moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
7 Mounting the Deflector
7.1 Mount the wheel guard.
1
► Attach the wheel guard to the gearbox, while
doing so, insert the nose (1) into the recess (2)
on the wheel guard.
► Turn-in and tighten the screw (3).
0458-480-0121-B
4
2 3
8 Mounting the Cutting
Attachment
8.1 Placing Power Tool on the
Ground
► Shut off the engine.
► Turn the power tool so that the cutting attach‐
ment mounting face is pointing up.
8.2 Blocking the shaft
3
2
To mount and remove the cutting attachments,
the shaft (1) must be blocked with the locking
pin (2) or Allen wrench (2). The parts are inclu‐
ded in the scope of delivery and are available as
special accessories.
► Push the locking pin (2) or Allen wrench (2) as
far as it will go into the hole (3) in the gear –
press gently
► Turn the shaft, nut or cutting attachment until
the locking pin engages and the shaft is
blocked
8.3 Fitting the mowing head with
screw mounting
Keep the supplement sheet for the mowing head
in a safe place.
English
1
2
9