Mounting The Deflector; Mounting The Cutting Attachment - Stihl FS 260 C Instruction Manual

English

Mounting the Deflector

Use the Right Deflector
1
WARNING
Deflector (1) is approved for mowing
heads only and must therefore be
mounted before fitting a mowing head.
2
WARNING
Deflector (2) is approved for grass
cutting blades and brush knives only and
must therefore be mounted before fitting
a grass cutting blade or brush knife.
22
3
4
WARNING
The limit stop (3) is approved as a
deflector for circular saw blades only
and must therefore be mounted before
fitting a circular saw blade. It is also
necessary to change the guard ring (5),
see "Mounting the Cutting Attachment" /
"Mounting Circular Saw Blades".
Mounting the Deflector
Deflectors (1 to 3) are mounted to the
gearbox in the same way.
6
5
Remove dirt from joints on gearbox
N
and defelector – make sure that no
dirt gets into the screw holes in the
gearbox.
Place the deflector on the gearbox
N
(5).
Insert the screws (6) and tighten
N
them down firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Use the Right Guard Ring
Your power tool comes standard with a
guard ring.
The guard ring is also available as a
special accessory.
The guard ring must be mounted with
particular care. Have this work
performed by your servicing dealer.
STIHL recommends a STIHL servicing
dealer.
FS 260 C, FS 360 C