Connect Power - Quantum LTO-9 HH SAS User Manual

Chapter 3: Installation

Connect Power

Figure 6 Example of
connecting the SAS device to
two servers
Connect Power
28
1 Tape drive
2 SAS connectors
3 SAS cables
4 Ensure the host adapter and the server are configured correctly for a
SAS bus operation. Refer to the host adapter and server
documentation for instructions.
5 If the power cord has already been installed, turn power to the tape
drive ON.
1 If the power cord has already been installed, skip to step 3.
2 Plug the power cord into the rear panel, then plug the other end
into a grounded electrical outlet.
3 Power-on the unit by pressing the Power button. The POST runs,
which checks all hardware except the drive head. During the POST,
the Single-character Display (SCD) flashes several segmented
4 SAS host adapter card
5 Servers
Quantum LTO-9 HH SAS User's Guide