Table of Contents
Advertisement
Note:
R To switch to the speaker, press MZN.
To switch back to the receiver, press MZN/
M
N.
R In step 1, you can store the dialed phone
number to the phonebook by pressing and
holding MFN W for a few seconds.
Making a call using the redial list
The last 5 phone numbers dialed are stored in
the redial list (48 digits max. each).
1
MEN REDIAL
2
MbN: Select the desired entry.
3
M
N
Pause (for PBX/long distance service
users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 32).
Example: If you need to dial the line access
number "9" when making outside calls with a
PBX:
1
9 a MDN (Pause)
2
Dial the phone number. a M
Note:
R A 3.5 second pause is inserted each time
MDN (Pause) is pressed.
Answering calls
1
Lift the handset and then press M
MZN when the unit rings.
R To answer a cellular call, you can also
press MCELLN.
2
When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Any key answer: You can answer the call by
pressing any dial key.
Auto talk: You can answer calls simply by
lifting the handset (page 40).
For assistance, please visit http://shop.panasonic.com/support
TGD66x(en)_0420_ver020.pdf
Temporary handset ringer off: You can turn
the ringer off temporarily by pressing M
soft key).
Adjusting the ringer volume
Press MDN or MCN repeatedly to select the
desired volume while ringing.
R To turn the ringer off, press MCN repeatedly.
n While the base unit is ringing for an
n While the base unit is in standby mode:
R To turn the ringer off, press and hold MkN
Note for handset and base unit:
R You can adjust the ringer volume for
R The ringer volume you set is kept for each
One-touch ringer off for the handset
N
Press and hold 0 (
turn the ringer off. While the ringer is turned
off, the handset will not ring for cellular calls or
for landline calls.
R You can turn the ringer on again by
N or
Useful features during a
call
Hold
1
2
3
23
Making/Answering Calls
Handset
Base unit
incoming call:
Press MjN or MkN repeatedly to select the
desired volume.
Press MjN or MkN repeatedly to select the
desired volume for landline call.
until the unit beeps.
cellular call and landline call by
programming (page 36, 38).
line (landline and cellular lines).
) until the unit beeps to
pressing and holding 0 (
beeps.
Press MMENUN during an outside call.
MbN: "Hold" a MSELECTN
To release hold on the cellular line:
*1
Press MCELLN.
N (left
) until the unit
23
2021/04/21
17:05:37
Advertisement
Table of Contents
