Electrolux Boiling pan Smart Service Manual page 22

Messages and error codes
Message
Red LED in START flashes. The following
text appears in the display:
TILTING
Xh XXmin XXX°C
ATOR 000rpm
AGITATOR
LID/GRID ON
Buzzer sounds and the following text appears
in the display:
ELEMENT
OVERHEATED
INTERRUPT?
YES PRESS STOP
NO PRESS START
The agitator has stopped. The following text
appears in the display:
AGITATOR OUT OF SERV
SEE OPERATION MAN.
PT-1000 FOOD
INTERRUPT
PT-1000 FOOD
SHORT CIRCUIT
PT-1000 ELEMENT
INTERRUPT
PT-1000 ELEMENT
SHORT CIRCUIT
WATER
INTERAPTION
SET WATER
UNSETTABLE DURING
WATER FILLING
TIME TO SERVICE
CONTINUE?
YES, PRESS STOP
EMERGENCY STOP
Red LED in the START button is lit.
Boiling is selected.
The boiling pan does NOT heat up.
22
(Valid from may 2016)
Cause
The pan is not in working posi-
tion.
The grid is fully or partly open.
Overheating of heating ele-
ment. The heat will shut off in
the event of a fault to the ele-
ment sensor.
STOP has been pressed
during operation.
Overloaded agitator
Interrupt in PT-1000 sensor
Short circuit in PT-1000 sensor
Interrupt in PT-1000 sensor
Short circuit in PT-1000 sensor
Fault in water meter
or
no water in to the pan
Manual water filling
in progress
Attained service intervals
The emergency stop is activated
SVI, SPI, during cooling, the
boiling pan has become de-
energized.
Action
Press Tilt return .
Close the grid and press Agitator start
• Press On/Off . The display goes out.
• Wait 5 seconds!
• Press On/Off . Display lights.
If the warning is still lit:
• Press On/Off to close the pan.
The display goes out.
See Warning! Overheating and contact authorised personnel.
Follow the instructions in the display.
• Press STOP to stop.
or
• Press START to return to the program.
• Press On/Off
The display goes out.
• Turn the main switch to position 0.
Wait for approx 1 minute.
• Turn the main switch to position 1.
• Press On/Off . Display lights.
Increase agitator speed or reduce the amount of food in
the pan
Contact authorised personnel.
Contact authorised personnel.
Contact authorised personnel.
Contact authorised personnel.
Contact authorised personnel.
Press STOP to interrupt the manual water filling.
Order service by authorized personnel.
Order the maintenance service kit ST12335-00.
Reset the emergency stop
Start the COOLING program and stop it after approximate-
ly 20 seconds.
Restart the BOILING program.
(Only boiling pans with Ice-water cooling).
.