HIKVISION 0500P Series Quick Start Manual
  1. Manuals
  2. Brands
  3. HIKVISION Manuals
  4. Switch
  5. 0500P Series
  6. Quick start manual
HIKVISION 0500P Series Quick Start Manual

HIKVISION 0500P Series Quick Start Manual

Gigabit poe switch
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
Gigabit PoE Switch
Quick Start Guide
UD28172B-A

Advertisement

Table of Contents
loading

Related Manuals for HIKVISION 0500P Series

Summary of Contents for HIKVISION 0500P Series

  • Page 1 Gigabit PoE Switch Quick Start Guide UD28172B-A...

  • Page 2: Applicable Models

    Preface Applicable Models This manual is applicable to 0500P series gigabit PoE switches. Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Provides additional information to emphasize or supplement important points of the main text.
  • Page 3  No naked flame sources, such as lighted candles, should be placed on the device.  The device shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the device. ...

  • Page 4: Product Introduction

    1 Introduction 1.1 Product Introduction 0500P series gigabit PoE switches are layer 2 PoE switches, providing advanced PoE power supply technology on the basis of high-performance access. The devices provide eight 10/100/1000 Mbps Ethernet ports to upload data via convergence switches. The devices are reliable, easy to install and maintain, and equipped with rapid switching functions.

  • Page 5: Desktop Installation

    Indicator/Port Description supply may be abnormal if more devices are connected. ● Unlit: The switch supplies power to a powered device (PD) normally. ● Solid on: The port is connected. ● Flashing: The port is transmitting LINK/ACT data. Indicator ● Unlit: The port is disconnected or connection is abnormal.

  • Page 6: Rack-Mounted Installation

    Note Ensure that the distance between the two screws equals to the ● distance between the two hanging holes. Set aside at least 4 mm of the screw bodies outside the wall. ● 3. Align the hanging holes with the screws, and hang the device on the screws.
  • Page 7 Rail-Mounted Installation 2. Press the DIN rail-mounted unit in quickly. 3 Grounding Connect Grounding Cable Grounding is used to quickly release overvoltage and overcurrent induced by lightening on the device, and to protect personal safety. Select an appropriate grounding method according to the installation conditions.
  • Page 8 3. Connect the other end of the grounding cable to the grounding terminal. Grounding with Angle Steel Connect RJ45 Port Use a network cable to connect the device to the RJ45 port of a peer device such as network camera, NVR, switch, etc. RJ45 Port Connection Connect SFP Optical Module Connecting an SFP optical module is supported when the device...
  • Page 9 2. Hold the SFP optical module from one side, and smoothly plug it into the device along the SFP port slot until the optical module and the device are closely attached. 3. After powering on the device, check the status of the optical port indicator.

Table of Contents