Galvin Engineering 656512 Installation Manuallines

Ss vandal resistant d/f plate assembly for pneumatic inwall cistern w/ cp bs raised buttons

Download this manual

Product Installation Guidelines

SS Vandal Resistant D/F Plate Assembly

for Pneumatic Inwall Cistern w/ CP BS

Raised Buttons

PRODUCT CODES

656512

SPECIFICATIONS

−

Face plate assembly features pneumatic dual flush push activation buttons for CIST19-PNEU-2 Slim-

Line Inwall Cistern.

−

2mm thick, Vandal resistant stainless steel faceplate.

TECHNICAL DATA

Activation

Connections

Hose Length

Finish

NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without

notice.

MOUNTING DETAILS

If a cut out is required, refer to the face plate position and cut out details below.

The push button can be positioned as preferred but consideration should be given to ensure it is easily

accessible for children and adults.

A 70mm x 140mm x 80mm cut out is required in the wall to fit the two push buttons. Drill two holes 160

mm from centres as shown for two nylon wall plugs 8 X 40 (NWP8).

Push Button

Pneumatic

3 metres

Polished

Version 1, 6

July 2022, Page 1 of 5

Page 1 Hose Length 3 metres Finish Polished NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without notice. MOUNTING DETAILS If a cut out is required, refer to the face plate position and cut out details below. The push button can be positioned as preferred but consideration should be given to ensure it is easily accessible for children and adults.
Page 3: Installation
July 2022, Page 3 of 5 INSTALLATION INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product.
Page 4 Apply a thin bead of silicon on the edge of cut out Mount the faceplate to the wall using the two countersunk torx screws. Ensure the screws are securely tightened and the faceplate is mounted flush to the wall. © Galvin Engineering Pty Ltd...
Page 5: Troubleshooting
WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.