Table of Contents
Advertisement
Agilent E1439 Programmer's Reference
Functions listed alphabetically
age1439_epoch_generate
ated.
age1439_epoch_generate_get
age1439_epoch_header
header. It can be used by the optical receiver to direct where to route and/or how to
process associated epoch data.
increment count for the epoch header.
age1439_epoch_header_enable
generated
age1439_epoch_header_enable_get
enable.
data epochs on the fiber interface.
age1439_error_message
calls.
age1439_error_query
ple clock
age1439_fiber_BOF
BOF events are transmitted
age1439_fiber_BOF_get
age1439_fiber_clear
age1439_fiber_crc
(on page 112)
redundancy checks.
age1439_fiber_crc_get
check setting.
age1439_fiber_error_get
ister.
age1439_fiber_flow_control
disabling transmitter flow control signals.
age1439_fiber_LED_get
front panel XMT/RCV led's.
age1439_fiber_mode_get
age1439_fiber_rcv_signal_get
DIR and NRDY bits on the fiber receiver.
optical signal is detected by the optical fiber interface receiver.
age1439_fiber_setup
face.
age1439_fiber_transfer_rate
age1439_fiber_transfer_rate_get
rate for fiber optic data.
age1439_fiber_verify
either an internal of external signal path.
68
(on page 97)
−controls whether or not data epochs are gener-
(on page 98)
− gets the current value of epochGenerate
(on page 98)
−sets the value of the first 32 bits of the epoch
(on page 98)
− returns the header value and the value of the
(on page 98)
− controls whether or not epoch headers are
(on page 98)
(on page 98)
−sets the parameters relevant to the transmission of
(on page 98)
−sets the size of data epochs in bytes.
(on page 98)
−returns the current size of data epochs.
(on page 98)
−returns error information obtained from function
(on page 102)
−queries the module for the most recent error.
(on page 103)
−enables and disables sync to an external sam-
(on page 104)
−gets the state of external sample sync
(on page 104)
−controls whether or not automatically generated
(on page 112)
−returns the current value of bofEnable
(on page 112)
−clears all data from the fiber interface FIFO buffers
(on page 106)
sets up the fiber interface to transmit and receive cyclic
−returns the current status of the cyclic redundancy
(on page 112)
−clears fiber errors from the status register
(on page 107)
−returns the value of the fiber interface error reg-
(on page 108)
−configures fiber flow control, enabling or
(on page 112)
−returns a data register indicating the state of the
(on page 110)
−selects the fiber interface mode.
(on page 112)
−gets the current mode of the fiber interface.
(on page 112)
−displays the current value of PIO1, PIO2,
(on page 111)
−returns a value indicating whether or not an
(on page 115)
−sets the parameters associated with the fiber inter-
(on page 112)
−selects the transfer rate for fiber optic data.
(on page 112)
(on page 112)
−preforms a verification of the fiber interface using
(on page 116)
−sends a BOF event used for synchronization
(on page 117)
−gets the debug level
−returns the current value of header
−gets the current selection of transfer
Advertisement
Chapters
Table of Contents
