Chapter 5 Device Settings; Pair Keyfob (Optional) - HIKVISION DS-K3G501S Series Quick Start Manual

Tripod turnstile

Hide thumbs Also See for DS-K3G501S Series:

User manual (133 pages)

Quick start manual (48 pages)

Table Of Contents

Table of Contents

DS-K3G501SX Series Tripod Turnstile Quick Start Guide

You can also set the turnstile to passing mode and memory mode, pair the keyfob, initialize the

hardware, switching between RS-485 communication mode and RS-232 communication mode, and

view relay output NO/NC diagram by setting the DIP switch on the access control board.

Normal Mode: The device will work properly.

●

Passing Mode: There are 9 passing modes, including controlled bi-direction, controlled entrance

●

and prohibited exit, controlled entrance and free exit, free bi-direction, free entrance and

controlled exit, free entrance and prohibited exit, prohibited bi-direction, prohibited entrance

and free exit.

Memory Mode: By default, the memory mode is enabled. When multiple cards are presented

●

and authenticated, it allows multiple persons passing through the lane. When it counts the

passing people number is equal to the card presented times, or no person passing through the

lane after the last person passing, the barriers will be closed.

Note

You can also set the DIP switch on the access control board to control the entrance and exit

controlling type, keyfob pairing, etc. For details about the DIP switch value, see DIP Switch .

5.1 Pair Keyfob (Optional)

Pair the remote control to the device through DIP switch to open/close the barrier remotely.

Before You Start

Ask our technique supports or sales and purchase the keyfob.

Steps

Note

Up to 32 keyfobs can be added to the turnstile.

●

You can set the keyfob to one-to-one mode or one-to-many mode via the DIP switch on the

●

keyfob. Here takes one-to-one mode as an example to explain. For one-to-many mode, see the

keyfob user manual.

One-to-One Mode

By default, the keyfob is in one-to-one mode. The keyfob's DIP switch is towards 1 (OFF). The

keyfob can control only one turnstile.

One-to-Many Mode

The keyfob's DIP switch is ON. In this mode, the keyfob can control multiple turnstiles.

1. Power off the turnstile.

2. Set the No.4 switch of the DIP Switch on the access control board to the ON side.