Contents Introduction Vehicle function compatibilities Pre-installation and application warnings Installation Wiring diagram Vehicle takeover connections Locating components in the vehicle Vehicle connections Connecting the module Module programming LED diagnostics and troubleshooting Soft reset Hard reset Feature programming Feature and option list Limited one year consumer warranty Quick reference guide...
Page 3
The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.
The steering lock connection is ONLY required if the connector is present in the vehicle. When using an external relay, use a 1N4002 diode or larger. Directed Part No. 8616 Minin Relays must be used for this connection. Refer to the "8616 wire and color reference" on the installation diagram.
This warranty gives you specific legal rights and you may also have other rights that vary from State to State. DIRECTED does not and has not authorized any person or entity to create for it any other obligation, promise, duty or obligation in connection with this Part.
Typically, users would have to remote start their vehicle, then get inside and press • Directed SmartStart application via your smartphone. the PTS button to perform a takeover. There is therefore a physical action required to drive away. With Get In and Go, you simply remote start the vehicle, unlock the If applicable, you can also start the engine remotely by pressing the Lock button 3 doors, get in and go...