Technical Information; Part Number; Cabinet Size/Gauge Letter Codes - Hawker PTO MOD3 Owner's Manual

PTO™ MOD3
There are two nameplates located on the outside of the charger and should be used to check the
application before installation. The "Main" nameplate includes the UL Model number and the
ratings of the cabinet at its full capacity, while the "Configured Ratings" nameplate includes the
Part number and the ratings of the cabinet as configured. The Configured Ratings nameplate label
must be replaced when adding or removing modules permanently in the field.
Part Number and UL Model Number
The UL Model Number specifies the characteristics of a full cabinet charger, while the Part Number
specifies the characteristics of the cabinet as configured, plus all options. The Part Number is
required in any discussion or correspondence regarding this unit.
Model type
Phase
(-) for Standard or (C) for CEC
Max DC Volts
Cabinet Size
Max DC Current @ Max DC Volts
Input Voltage Code
Options
The following table describes the letter codes to be used in charger part numbers to indicate the
DC output voltage(s) of the charger.
Letter
Code
C
F
Owner's Manual

TECHNICAL INFORMATION

PTOM3-48F-240YR

Cabinet Size/Gauge Letter Codes

Module Standard Cable
Positions Gauge
3
6
2/0 Three slot, 3.5kW cabinet
3/0 Six slot, 3.5kW cabinet
4
AM-HPTOM3-OM
Rev AB February 2020
Comments