Hawker Life IQ Technical Manual
Hawker Life IQ Technical Manual

Hawker Life IQ Technical Manual

Single phase and 3-phase chargers

Advertisement

Technical Manual
GB
Hawker
®
Life IQ
TM
Single phase and 3-phase
chargers
1

Advertisement

Table of Contents
loading

Summary of Contents for Hawker Life IQ

  • Page 1 Technical Manual Hawker ® Life IQ Single phase and 3-phase chargers...
  • Page 2: Table Of Contents

    Recommendations for safe operation FEATURES...................... 4 This manual should be carefully read, prior to using the equipment, by anyone intending to use the charger. The Life IQ: EXTERNAL COMPONENTS................4 • Must not have its air circulation impaired in any way, primarily around the air inlet areas.
  • Page 3: Limitations Of Use

    This allows the charger to work over a wide range of battery capacities. The control of the charging factor is absolute on all battery types. The Life IQ chargers adapt to battery capacity and depth of discharge.
  • Page 4: Description

    Alternating, battery charged with defect Green Orange pump or overdischarge FEATURES The Life IQ chargers are: Functions of keys The keys offer the following general functions: fitted as standard with: • A wide LCD display with a five colour backlight indicating the status...
  • Page 5: The Menus

    This manually decreases the maximum output current of the charger. or fault pump*. Equalisation (*): see § Fault codes These parameters are not valid for GEL and Hawker XFC batteries. Manu Current This defines the equalisation or desulphation current for a manual start.
  • Page 6: Parameters

    USING THE CHARGER Cable Length Selects the length of battery-charger DC cable from 1 m to 11 m. UNPACKING Section The charger is delivered with the following: Defines the battery-charger DC cable cross-section. Select one section • 2m AC mains cable. over the list of values (10, 16, 25, 35, 50, 70, 95 or 120 mm²).
  • Page 7: Electrical Connections

    Standard charger model D - Fixing L x H: 470 x 350 mm Standard charger model E with optional pump - Fixing L x H: 470 x 350 mm Standard charger model D with optional pump - ELECTRICAL CONNECTIONS Fixing L x H: 470 x 350 mm Single phase and 3-phase input Connection to the mains supply will be 230V AC single phase or 400V AC 3-phase and must be connected using a suitable plug and adequately...
  • Page 8: Factory Setup

    Ref. Without Wi-IQ ® With Wi-IQ FACTORY SETUP The charger is delivered with a factory setup as follows: Charger status (CHARGE, AVAIL, DEFAULT, EQUAL..), possible pump fault or DF4. Profile: As ordered Alternating display of battery voltage, voltage per cell, Ah Output DC cable length: restored, charging time, remaining charging time, percentage Configuration:...
  • Page 9: Historical Data Per Charge

    Automatic start TEMP* Critical battery Wait until the battery If the equalisation charge has been programmed temperature. temperature cools down, check ( Configuration/Equalisation menu), the equalisation charge is initiated the battery state (water, profile) automatically. Verify the set up of temperature If the battery remains connected, and in order to maintain it in a fully in the menu Configuration- charged condition, refresh charges followed by an equalisation charge...
  • Page 10 Wherever you do business, EnerSys ® can support you with motive power energy. The Hawker ® branded battery range, matched chargers and systems provide trouble free perfor mance under the most demanding service conditions. Our strategically located manufacturing plants are efficient and responsive with a culture of continuous improvement and added value for our business partners.

Table of Contents