Using The Ice Maker - HOMCOM 800-139 Assembly Instruction Manual

USING THE ICE MAKER

Operation panel and display area
1. Remove the cover of the reservoir and fill with drinkable water.
Keep the water below the maximum level. The maximum level will be marked
with FULL,as shown in the picture below.
Warning: Do not pour water into the internal tank underneath the ice basket.
The tank is too small and will affect the machine's performance.
2.Turning on the machine: Plug in the unit, and the power <
The current ambient temperature will display at the top left corner. For example,
'80F' means 80 Fahrenheit.
Press the 'ON/OFF' button to start the unit, and the water will fill the tank to the
standard water level. The compressor will begin to make ice cubes. The ice cube
sign < > will rotate, and the ambient temperature will disappear. A few minutes
into the process, flashing digits will display at the top left corner. For example, the
digits will display '10M', meaning the cycle has 10 minutes until completion.
3. When ice maker harvest, symbol<
reservoir to bottom water tank through solenoid valve, the symbol <
,when the water in the bottom water tank is full, the symbol <
the next ice making cycle start again. When there is no water in the water
reservoir, the symbol <
Turn off the unit and fill water again, then restart the unit to make ice cube. Or fill
water directly and wait 20mins,the unit will restart .
Note: The ice making cycle lasts approximately 13 to 25 minutes, depending on
the ambient temperature. The hotter the temperature, the longer it could take.
First-time use might take slightly longer, depending on the water temperature. The
cycle time will not exceed 35 minutes.
To change the thickness of the ice cubes during the cycle, press '+' or '-' to change
the time. Press once to increase/decrease by one minute, with six minutes being
the maximum. This can only be done from a new cycle.
4.The unit will stop when the 'Ice Full' sign
restart the ice making cycle.
Holding the 'ON/OFF' button for longer than five seconds during the ice making
cycle to switch to ice harvesting.
EN
OPERATION
AREA
Cover for the water reservoir
> flash, the water will flow from top water
> will keep on.
is on. Take out the ice cubes to
6
DISPLAY OPERATION
AREA
AREA
> sign will flash.
> will be on
> will be off, then