Handling And Lifting; Safety Devices And Accessories; Position And Fixing - KBS NGWT 7-55/SN Installation, Operation And Maintenance Instructions

4.2 Handling and Lifting

The appliance can be handled using fork-lift or hook equipment of suitable load-carrying capacity. Before lifting,
check the position of the load's centre of gravity.
Important! When engaging with the lifting equipment, watch out for the gas supply.

4.3 Safety Devices and Accessories

The appliance is provided with safety devices. The additional devices must be added if necessary to comply
with the relevant legal requirement during the installation.
Important! Make the daily check that the safety devices are properly install and in good working
order.
The appliance is equipped with the included or optional accessories. There is G20 Conversion Kit as included
accessory.

4.4 Position and Fixing

1. Authorized personnel must do the installation.
2. Install the appliance according to National Safety Standard about gas-heated standard.
3. Place the appliance in good ventilated room with permanent ventilation ducts to guarantee sufficient
exchange of air and keep the work place healthy.
4. If the Gas Wok Ring Table not connected to a flue, it is recommended to install it under efficient hood, which
could evacuate burned gases and cooking steams. Below is construction type according to National
Regulations:
A : Appliance without fan and does not have connection to a flue or to a device for evacuating combustion
1
products outside the room. The combustion air and burned gas mixed in one room.
5. Make sure that any object around or under Gas Wok Ring Table does not obstruct air volume required for
combustion.
6. Put away any flammable materials near Gas Wok Ring Table.
7. When the appliance is freestanding, keep a distance at least 10 cm from side, and rear walls. Especially
when the appliance close to wall and does not protected with fire-resistant materials made.
8. Install the appliance separately or side by side with other appliance according to recommended range.
9. Put Gas Wok Ring Table on solid, flat, and horizontal floor.
10.Adjust the height of the four feet by using brackets.
11. Before turn the appliance ON, remove the protective film. Remove any adhesive with appropriate solvent.
Eliminate all packaging material according to national laws.
Amicus- Gas-20190620
16
GB-Gas Wok Ring Table