Golden Technologies Compass TRO Owner's Manual page 13

Compass TRO Owner's Manual – Models GP615SS, GP615CC
SEAT REMOVAL/INSTALLATION
Note: The seat assembly weighs about 48 pounds. Please ask for help if you do
not feel capable of safely lifting that much weight. Removal of arms will
significantly reduce the weight of seat.
Note: If a tilt seating system was purchased, please refer to the installation
instructions provided by its manufacturer.
REMOVAL
1. Disconnect the controller cable from the joystick. "Unclip" from arm and
remove Velcro® tie-wraps.
See figure 2 on page 12.
2. Lift the front and rear seat lock handles and slide the seat until all (4) of the
seat guides are out of the receivers.
INSTALLATION
The seat can be installed from either side of the power chair.
1. To install the seat, align the seat guides (front and rear) with the seat receivers
(front and rear).
2. Slide the seat towards the center of the power chair until the seat locks
securely in place. The front and rear locks must engage.
3. Reconnect the controller cable to the joystick cable.
LOCKED BEFORE OPERATING YOUR POWER CHAIR.
Front Seat Lock
Handle
Rear Seat Lock
Handle
ASSEMBLY
BE SURE THE SEAT IS CORRECTLY INSTALLED AND
Figure 3
Figure 5
Rear Seat Lock
Handle
Seat Locking
H
andle
Seat Height &
Angle
Adjustment Pins
13
Revised 02/13/09
Front Seat Lock
Handle
Figure 4
Seat Guides
Seat Receiver
Figure 6