Table of Contents
Advertisement
Filling the Clean Water Tank
View our full lineup of powerful carpet cleaning formulas
at BISSELL-commercial.co.uk.
Always use genuine BISSELL® Commercial formulas in your machine. Other formulas may harm the
machine. Do not use boiling water. Do not heat water or tank in microwave.
1.
Pull the clean water tank up
to remove. Unscrew the cap
from the bottom of the tank.
*Compatible BISSELL formulas include: BISSELL Commercial Multi-Surface Formula
Cleaning Your Floors
1.
Plug into a properly
grounded outlet. Press power
switch on back of machine to
ON position.
ATTENTION
WARNING
Commercial cleaning formula intended for use with the hard floor device.
4 global.BISSELL.com
2.
Add formula* and warm tap
water (140°F/60°C max).
BISSELL Commercial Formula
(6:1 water to formula ratio):
Add 148 mL of formula. Add
water to MAX FILL line.
For other recommended
formula: Follow manufacturers
solution ratio for cleaning and
sanitizing hard floors and fill to
MAX FILL line.
2.
Press the power standby
button on the handle to begin
cleaning.
Recline to start the brush roll
spinning. Brush roll will not
spin when machine is upright.
This machine is designed to be used on sealed hard floors.
To reduce the risk of fire and electric shock due to internal component damage, use only BISSELL
3.
Screw the cap back on,
align clean water tank with
the grooves on the back of the
machine and slide it until it
clicks into place.
Power
Standby
3.
Before each use, hold the
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights will illuminate when
holding the trigger. Bubbles will
appear in the brush roll window
when the solution is flowing.
10s
Advertisement
Table of Contents
