Table of Contents
Advertisement
Filling the Clean Water Tank
View our full lineup of powerful carpet cleaning formulas at BISSELLcommercial.com.
Always use genuine BISSELL® formulas or low foaming, neutral pH formulas in your machine. Other
formulas may harm the machine. Do not use boiling water. Do not heat water or tank in microwave.
1.
Pull the clean water tank up
to remove. Unscrew the cap
from the bottom of the tank.
*Compatible BISSELL formulas include: Bissell® Hard Floor Sanitize
Cleaning Your Floors
1.
Plug into a properly
grounded outlet. Press the
power button to turn the
machine ON.
The dry vacuum will turn on.
ATTENTION
WARNING
cleaning formula intended for use with the hard floor device.
4 BISSELLcommercial.com
2.
Add formula* and warm tap
water (140°F/60°C max).
BISSELL Formula (6:1 water to
formula ratio):
Add 148 mL of formula.
Add water to MAX FILL line.
For other recommended
formula: Follow manufacturers
solution ratio for cleaning and
sanitizing hard floors and fill to
MAX FILL line.
2.
Recline to start the brush
roll spinning. Brush roll will not
spin when machine is upright.
This machine is designed to be used on sealed hard floors.
To reduce the risk of fire and electric shock due to internal component damage, use only BISSELL
3.
Screw the cap back on,
align clean water tank with
the grooves on the back of the
machine and slide it until it
clicks into place.
3.
Before each use, hold the
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights will illuminate when
holding the trigger. Bubbles will
appear in the brush roll window
when the solution is flowing.
10s
Advertisement
Table of Contents
