Table of Contents
Advertisement
Antenna Placement
This is for the graphics
Proper antenna placement can help improve Access Point performance. Use the
following guidelines:
• Place the antenna as high as possible in an office environment above cubicle
• Do not place a sheet of metal between two antennas.
• Make sure that the two antennas that are communicating are in the same
• If the Access Point is mounted towards the ceiling, do not put the antenna on
Troubleshooting
The Access Point is very easy to install and operate. If you do experience
difficulties however, use the information in this section to help diagnose and
solve the problem. If you cannot resolve the problem, contact your Intermec
service representative.
Problem:
Solutions:
walls.
plane. For example, do not lie one antenna on its side and have its partner
standing upright.
top of it.
No response from the Access Point when configuring
remotely.
1. Verify that the IP address for the configuration tool PC
is set properly in the CFG.CFG file.
2. Using local management, verify that the IP address for
the Access Point is set correctly.
3. Verify that you are not duplicating IP addresses on
your network.
4. Verify that no IP protocol stacks are loaded.
Helpful Hints and Troubleshooting
4
4-5
Advertisement
Table of Contents
