Navigating Through The Configuration Application; Before You Run The Configuration Application - Intermec 0100A User Manual

This chapter explains how to configure the Access Point locally and remotely using
This is for the illustrations
the Access Point configuration software.

Navigating Through the Configuration Application

When running the configuration application software, you can use either a
mouse or keyboard to make selections. When using a keyboard:
• To make a selection, press the Alt key followed by the highlighted letter.
• To cycle through the buttons displayed, press the Tab key.
• To find out more information about the dialog box, choose the Help button.

Before You Run the Configuration Application

Before you run the configuration software, you need to install it on your host
PC. Then, you need to decide if you want to configure the Access Point by
hooking it up to your PC (locally), or if you are going to configure it across the
network (remotely).
To install the configuration software on your PC
1. Insert the configuration software disk into your host PC. Create a new
2. Choose one:
directory on your host PC for the configuration software and copy the
software into this directory. For example:
C:\>MD AP
C:\>CD AP
C:\AP>COPY A:*.*
Note: If your 3.5 inch drive is the B drive of your PC, substitute B for A in the
command line.
• If you want to configure the Access Point locally, use the instructions in
the next section.
• If you want to configure the Access Point remotely, use the instructions
in the section, "Configuring the Access Point Remotely," later in this
chapter.
Configuring the Access Point
3
3-3