Advertisement
S10
Presets
The
Adamson Load
Library, contains presets designed for a variety of S10 applications. Each preset is intended to be
phase-aligned with either the S118 or S119 subwoofers within the EQ overlap region.
For a master list, please refer to the
When cabinets and subwoofers are positioned separately, phase alignment should
be measured with suitable software.
S10 Lipfill
S10 Compact
Intended for use with
Intended for use
with a single S10
an array of 4 S10 over
2 or 3 subs
Control
Array Shaping overlays (found in the Array Shaping folders of the
section of Lake Controller to adjust the contour of the array. Recalling the appropriate EQ overlay or preset for the
number of cabinets being used will provide the standard Adamson frequency response of your array, compensating for
different low-frequency coupling.
Tilt overlays (found in the Array Shaping folders of the
response of an array. Tilt overlays apply a filter, centred at 1kHz, which reaches the noted decibel cut or boost at the
extreme ends of the listening spectrum. For example, a +1 Tilt will apply +1 decibel at 20kHz and -1 decibel at 20Hz.
Alternately, a -2 Tilt will apply -2 decibels at 20kHz and +2 decibels at 20Hz.
Please refer to the
Adamson PLM & Lake Handbook
overlays.
Adamson Systems Engineering |
Adamson PLM & Lake Handbook.
S10 Short
Intended for use with
an array of 5-6 S10
for detailed instructions on recalling Tilt and Array Shaping
S10 User Manual
S10 Array
Intended for use with
an array of 7-11 S10
Adamson Load
Adamson Load
Library) can be used to alter the overall acoustic
S10 Large
Intended for use with
an array of 12 or more
S10
Library) can be recalled in the EQ
Page 7
Advertisement
