Table of Contents
Advertisement
Cooling Your Room
You must select the Cool mode if you wish to adjust the :
Cooling temperature
Fan speed when cooling
1
If necessary, press the
Result:
The power indicator on the control panel comes on.
The indoor unit beeps.
The air conditioner starts up in the Cool mode.
IMPORTANT
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Switched on
Stopped
lt will start up normally after three minutes.
2
If the
is not displayed on the control panel, press the
remote control one or more times until it appears.
Result:
The indoor unit beeps each time you press the
The air conditioner runs in the Cool mode.
You can change modes at any time.
N N
o o
t t
e e
N N
o o
t t
e e
3
To adjust the temperature, press the
buttons on the control panel one or more times until the required temperature is
displayed. Possible temperatures are between 18
Result:
Each time you press the
- The temperature is adjusted by 1
- The indoor unit beeps.
The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
If the room temperature reachs the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4
Select the fan speed by pressing the
or
button one or more times until the required setting is displayed :
Automatic(rotated :
Low
Medium
High
Result:
Each time you press the
5
To control the direction of the air flow, refer to page 16.
(On/Off) button.
buttons on the remote control or
O
C and 30
buttons:
O
C.
button on the remote control
button, the indoor unit beeps.
button on the
button.
O
C inclusive.
)
9
E-
Advertisement
Table of Contents
