Table Of Contents - Intermec ScanImage 1470 User Manual

Table of contents

Section 3 - Installing the ScanImage as an RS-232 output
device
Single RS-232 mode .................................................................3-1
-Single RS-232 Mode (P/N 9X2)........................................3-1
-ScanImage 9X2 With Single RS-232 Output ..................3-2
-Pin Assignments for Single Output
Cable Management Module.............................................3-4
Dual RS-232 mode ...................................................................3-5
-Dual RS-232 Mode...........................................................3-5
-ScanImage 9X2 With DUAL RS-232 Ouput Option .......3-6
-Standard Dual RS-232 Option
(P/N 901196 or 700352) ...................................................3-8
RS-232 interface parameters ...................................................3-9
-RS-232 Enable .................................................................3-9
-Baud Rate ...................................................................... 3-10
-Data/Stop/Parity............................................................ 3-11
-End of message Control Codes ...................................... 3-12
-Protocols for Contolling Data Transmission ................. 3-13
Section 4 - Installing the ScanImage as a Keyboard
Wedge
Keyboard Wedge mode.............................................................4-1
-Keyboard Wedge Mode (P/N 9X7) ...................................4-1
-ScanImage 9X7 Wedge Connection with
Cable Management Module.............................................4-2
-Compose Terminal Type..................................................4-4
-End of message Control Codes ........................................4-5
-Upper Lower Case Options .............................................4-6
-Alt Mode ..........................................................................4-6
©1994 UBI Scanimage User's Manual Page v