Intermec ScanImage 1470 User Manual page 18

SECTION 1
Special Features
Return to Factory Defaults
At any time, the ScanImage can have its settings reset to
factory defaults which are indicated by (*) asterisk throughout
the manual. By scanning the Return to Default Parameters
bar code label, the ScanImage will return back to the
indicated default settings.
Autostand
The ScanImage may be configured for use with UBI's
Autostand, which allows the scanner to work in a hands-free
mode. The ScanImage will revert to its normal method of trigger
activation when temporarily removed from the stand to read
large or bulky items.
The autostand mode is a factory installed feature that is added
to 91X UBI laser scanners. The user has the capability to enable
the autostand mode by scanning the Autostand Enable bar
code. The scanner will respond by emitting a continuous, low
level, red beam of light. The autostand mode is deactivated by
scanning Autostand Disable bar code.
Marker Beam
The Marker Beam is available on all scanimage and
automatically selected in the long range 95X, Etra Long Range
97X and Ultra Long Range 99X ScanImage. The marker beam is
a stationary spot that appears momentarily before the
ScanImage begins scanning. It shows the operator exactly
where the scanner is aimed for error-free scanning of hard-to-
target symbols. The marker beam can be disabled or enabled at
any time.
Page 1-4 User's Manual 1994 UBI ScanImage