Preparing The Scanimage For Configuration - Intermec ScanImage 1470 User Manual

Preparing the ScanImage for configuration

To prepare the ScanImage for configuration follow these steps:
1. Verify that the correct ScanImage cables and accessories, if
any were ordered, have been received.
2. Turn off power to the terminal to which the ScanImage will
be connected.
3. Install the ScanImage according to the instructions in the
following sections. Chapter two describes installation of
wand emulation mode, chapter three RS-232, and chapter
four wedge installation.
4. Connect the power supply, if necessary. Power up the
host according to the interface (except 9x1), the ScanImage
will beep five or six times indicating that hookup has been
completed.
5. Type on the keyboard to verify that the terminal is
transparent to the system.
6. Test the ScanImage by scanning your bar code label(s). If
further changes are required go to the appropriate family
in Part II and make the additional changes.
Page 1-2 User's Manual
SECTION 1
1994 UBI ScanImage