Check After Installation - D&H FH16A Manual

Locomotive/Vehicle function decoder
42 42
The wires of an additionally connected SUSI module are connected according to the following scheme:
red wire ........................ SUSI supply voltage (ZVS) or supply voltage (VS) if no ZVS available
blue wire ....................... SUSI clock (ZCLK)
gray wire ....................... SUSI data (ZDAT)
black wire ..................... Ground (GND)
Function outputs:
The function outputs AUX* are possibly on the underside of the decoder and must be connected to the consumer with
individual wires or – if unamplified – via appropriate amplifiers.
Notice:
In case of an incorrect wiring of motor, lighting and track, there is no need to solder off the wires as the assignment can be
interchanged electronically by programming (see setting options of the respective system format: CV51 or par031, par032,
par033).

5.4 Check after installation

The first test should be made in programming mode (e.g. by reading out the address). If there is not correct check back
signal to the central unit ("Error"), check again the mapping of the connection or the electrical separation of the motor from
the chassis.
Fahrzeug-/Funktionsdecoder
from firmware version 3.12 ab Firmware-Version 1.11