Check After Installation; System Format Dcc; Functions - D&H PD10MU User Manual

34 34
Functionsausgänge:
The function outputs AUX* may be located on the bottom side of the decoder and must be connected to the consumers
with extra wires.
Notice:
In case of an incorrect wiring of motor, lighting and track, there is no need to solder off the wires as the assignment can be
interchanged electronically by programming (see CV51).

5.4 Check after installation

The first test should be made in programming mode (e.g. by reading out the address). If there is not correct check back
signal to the central unit ("Error"), check again the mapping of the connection or the electrical separation of the motor from
the chassis.
6

System format DCC

6.1 Functions

Short address ................................................... 1-27
Long address .......................................... 0001-9999
Speed steps ............................................ 14, 28,126
Speed steps (internal) ........................................ 127
Front light/rear light (dimmable) ..........................yes
Additional functions (dimmable) ............................ 2
Functions total ..................................................... 28
Operation with brake diodes ..............................yes
Operation with brake generators ........................yes
Consist mode .....................................................yes
Programming On The Main ................................yes
Locomotive number output ................................yes
Locomotive decoder PD10MU Fahrzeug-/Funktionsdecoder
from firmware version 3.12 ab Firmware-Version 1.11