Removing The Main Unit; Cautions On Wiring; Vrx935Vd - Clarion ProAudio VRX 935VD VRX935VD VRX935VD Owners & Installation Manual

6.

REMOVING THE MAIN UNIT

1. When the rear of the main unit has been se-
cured with the method shown in Figure 6 un-
fasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab B of
the spring into hole A of the hook plate, then
Universal mounting bracket
2-Hook plate
Outer escutcheon
7.

CAUTIONS ON WIRING

1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original.
4. To replace the fuse, remove the old fuse of
the power supply lead and insert the new
one. (Figure10)
∗ Power supply lead for the tuner amp unit : 15A
FUSE
∗ Power supply lead for the main unit : 3A FUSE
pull the main unit out by the hook plate. (In-
sert both the right and left edges of the hook
plate.) (Figure 9)
Note: Keep the hook plate. You cannot remove the
main unit without disengaging the hook plate.
Instrument panel
Main
Unit
A B
Figure 9
Note: There are various types of fuse holder. Do not
let the battery side touch other metal parts.
After the connection, fix the lead by a clamp or
insulation tape for protection.
Fuse holder
Spring
CAUTION
Fuse
Figure 10

VRX935VD

67