Table of Contents
Advertisement
6.
REMOVING THE MAIN UNIT
1. When the rear of the main unit has been se-
cured with the method shown in Figure 6
unfasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab
7.
CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original.
4. When any fuse is to be replaced, pull out the
fuse (15A) at the rear of the main unit and
put in a new one (Fig.10).
the spring into hole
pull the main unit out by the hook plate. (In-
sert both the right and left edges of the hook
plate.) (Figure 9)
Note: Keep the hook plate. You cannot remove the
B
of
main unit without disengaging the hook plate.
After the connection, fix the lead by a clamp
or insulation tape for protection.
A
of the hook plate, then
Figure 10
CAUTION
VRX633R
51
Advertisement
Table of Contents
