Step 1: Cut Girder And C-Channel (As Required); Step 2: Check Camber (As Required) - Yale SHAW-BOX YK Series Assembly & Instruction Manual

STEP 1:
CUT GIRDER AND C-CHANNEL (AS REQUIRED)
WARNING
Selection of structural steel beams must be verified
by qualified engineer. IT IS IMPORTANT THAT
ALL INSTRUCTIONS BE FOLLOWED AND THAT
COMPONENT APPLICATION LIMITS NOT BE
EXCEEDED.
Check your configuration to see if a capping channel is required.
STEP 2:
CHECK CAMBER (AS REQUIRED)
CUT LENGTH TO BE DETERMINED BY SPAN LENGTH
10 P/N: C11746310 REV. AB June 2022