Contents About these Instructions Target groups Explanation of symbols Additional documents Feedback on these instructions Notes on the Product Product identification Manufacturer and service Software-Supported IO-Link-Parameterization IO-Link Parameters (Firmware 1.1) General Parameters Process Data (Cyclic Communication) Acyclic Communication (via ORDO) 4.3.1 General Specific...
Should you have any suggestions for a better design or any information is missing from the instructions, please send your suggestions to techdoc@turck.com. Hans Turck GmbH & Co. KG | Witzlebenstraße 7, 45472 Mülheim/Ruhr, Germany | T +49 208 4952-0 | more@turck.com | www.turck.com...
45472 Mülheim an der Ruhr Germany Turck supports you with your projects, from initial analysis to the commissioning of your ap- plication. The Turck product database contains software tools for programming, configuration or commissioning, data sheets and CAD files in numerous export formats. You can access the product database at the following address: http://www.turck.de/products/...
On-Request Data Objects (ORDO), the parameters can be written into the device (Write) or the device status can be read from the device (Read). Hans Turck GmbH & Co. KG | Witzlebenstraße 7, 45472 Mülheim/Ruhr, Germany | T +49 208 4952-0 | more@turck.com | www.turck.com...
General Parameters Name Index Index Access Byte Type Description (dec.) (hex.) count Vendor name 0x10 Read Manufacturer ID, fixed: “Turck” Vendor text 0x11 Read Fixed: “www.turck.com” Product name 0x12 Read Manufacturer‘s device designation, fixed: e. g. “FMX-IM-3UP63FX” Product ID 0x13 Read Device ID, fixed: e.
DeltaFlow acceptably small (DeltaFlow) DeltaFlow low DeltaFlow medium DeltaFlow high Teach status 0x92 Read Uint8 Teachfunction approved Teachfunction not approved Hans Turck GmbH & Co. KG | Witzlebenstraße 7, 45472 Mülheim/Ruhr, Germany | T +49 208 4952-0 | more@turck.com | www.turck.com...
Page 9
Name Index Index Access Bit Type Value Description (dec.) (hex.) count Read Public Flag 0x0130 Read Flag DeltaFlow too high Registers Short circuit DOut 1 (Flow) (only FM(X)-IM-3UP63FX) Short circuit DOut 2 (Temp) (only FM(X)-IM-3UP63FX and FM-IM-2UPLi63FX) Short circuit DOut 3 (Fault) (only FM(X)-IM-3UP63FX and FM-IM-2UPLi63FX) Short circuit sensor...
Error messages 5.4.1 Error messages FM(X)-IM-3UP63FX Name Index Index Access Bit Description (dec.) (hex.) count Fault indication 0x90 Read Gap between MAX and MIN too small Flow rate above indicating range Flow rate below indicating range Flow rate above operating range Temperature above indicating range Temperature below indicating range Temperature above operating range...
General fault (manual reset needed) Wire break current source Fault current source or load too high (switch-off of current source; Power-reset needed) Hans Turck GmbH & Co. KG | Witzlebenstraße 7, 45472 Mülheim/Ruhr, Germany | T +49 208 4952-0 | more@turck.com | www.turck.com...