Activating The Cutter (Pd42 Only); Controlling The Cutter (Fingerprint); Controlling The Cutter (Ipl) - Intermec EasyCoder PD41 Installation Instructions Manual

Activating the Cutter (PD42 only)

If you are using a PD42 printer you can activate the cutter directly from the
display.
To activate the cutter on a PD42 printer
1 Turn the printer on.
2 Press Setup (
3 Navigate to Configuration > Cutter > Enable.
4 Press Acknowledge (
5 Press Setup again to exit setup.

Controlling the Cutter (Fingerprint)

The cutter function is controlled with the Fingerprint commands CUT and
CUT ON/OFF. Please refer to the Fingerprint Programmer's Reference Manual
(P/N 937-005-xxx) for more information.

Controlling the Cutter (IPL)

The cutter function is controlled with the IPL commands listed below. Please
refer to the IPL Programmer's Reference Manual (P/N 066396-xxx) for more
information.
IPL Cutter Commands
Command
<SO>
<SI>c1
<SI>c0

).
).
EasyCoder PD41/PD42 Cutter Kit Installation Instructions
Description
Cut
Enable cutter
Disable cutter