Table of Contents
Advertisement
UBI EasyCoder 71 – Programming
PRINT PARAMETERS COMMANDS, cont'd.
S
Speed Select
D
Heat Density Select
Used for:
Global Setup & Form Edit Mode (resets Global Setup)
Syntax:
Sa
a
=
0
Print speed 1.0 inch/sec. (25 mm/sec.)
1
Print speed 1.5 inch/sec. (37 mm/sec.)
2
Print speed 2.0 inch/sec. (50 mm/sec.)
Used for:
Global Setup & Form Edit Mode (resets Global Setup)
Syntax:
Da
a
=
Density value 0 to 7.
0 is the lightest printing and 7 is the darkest.
where...
where...
58
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the EasyCoder 71 and is the answer not in the manual?
Questions and answers