Printhead Replacement - Intermec EasyCoder 601XP Install Manual

Step-by-step instructions
1
Turn off the power.
Remove any paper or transfer ribbon.
3
Disconnect the hooked printhead bracket fingers from
shaft. Carefully pull out the printhead as far as the cables
5
Connect the cables to the replacement printhead.
Blue connector to the left, white connector to the right.
Intermec EasyCoder 601 XP Thermal Printhead– Installation Instructions Ed.2
allow.
Blue
White
2
Using your fingers, pull the printhead bracket away from
the magnet in the lift arm. Do not use any tools.
4
Disconnect the two cables from the printhead. Note the
snap-lock on the white connector. Pull at the connectors
– not at the cables!
6
Fit the hooks of the printhead bracket fingers onto the
headlift shaft. Close the printhead so the magnet engages
the printhead bracket. Turn on the power.

Printhead Replacement

2