Intermec EasyCoder 601XP Installation Instructions page 3

Installation
Ribbon Low Sensor
NOTE!
The Ribbon Unwind Unit
does not need to be dismounted!
Information in this manual is subject to change without prior notice and does not represent a commitment
on the part of Intermec Printer AB.
© Copyright Intermec PTC AB 1998. All rights reserved. Published in Sweden.
EasyCoder and Fingerprint are registered trademarks of Intermec Technologies Corp.
Torx is a registered trademark of Camcar Division of Textron Inc.
Intermec EasyCoder 501/601 XP Ribbon Low Sensor – Installation Instructions Ed. 2
• Open the right-hand door.
• Turn off the power and remove the left-hand cover.
• From the paper compartment side, insert the connector and cable
through the square hole in the centre-line wall.
• Insert the sensor under the code disk of the ribbon unwind unit
so the disc will run in the U-shaped slot between the receiver and
transmitter. There is no need to dismount the ribbon unwind unit.
• Attach the sensor to the centre-line wall by means of one #T10
Torx screw. Check that the code disc can rotate freely.
• Connect the cable to P57 on the CPU board.
• Put back the left-hand cover.
• Turn on the power and check that the sensor works by reading
its values using the Intermec Fingerprint instruction PRINT
SYSVAR(13) while manually rotating the ribbon unwind spool.
Ribbon Low Sensor
#T10 Torx Screw
2