EasyCoder 401/501/601 – Installation Instructions
LABEL-TAKEN SENSOR KIT, cont'd.
Step-by-Step Installation
Instructions
Turn off the power. For double security, pull the power cord out
of the mains receptacle at the rear plate of the printer.
Open the right-hand door.
Open the front hatch.
Using a #T10 Torx screwdriver, remove the six or eight screws
that hold the left-hand cover (see illustration).
Screws
Screws
Remove the cover.
Press the reflecting sensor assembly into the bracket as illustrated
below.
Bracket
Sensor Assy.
Continued!
2