Confi Guration & Assembly - Pelsue AC-R Series Product Manual

3.0 - Confi guration & Assembly
Upon initial receipt of the #AC-R Series Device, inspect the packaging for any evidence that the product may have been
damaged in shipment. While unpacking the product, inspect all of the components for damage. If damage to any of
the components is discovered, DO NOT USE THE PRODUCT! Alert the shipping carrier immediately of the damage to
the shipment.
SPEED
HANDLE
MANUFACTURED BY
T.A. PELSUE CO. ENGLEWOOD, COLORADO 80110
Figure 3d: Decal
#102072-002
Figure 3e: Decal
#500234-001
Verify that all parts are present before product use.
The AC-R Series Anchor Clamp is shipped fully assembled.
1. Ensure that the product has been shipped with all the necessary components and is in working order
(Refer to Fig. #3a or #3b)
**Refer to the Figures above to determine if replacement parts are required. Replacement parts can be obtained from
the T.A. Pelsue Company at 800-525-8460.
Page 8
Figure 3a: #AC-##R
Anchor Clamp
(General Assembly)
OUTER
JAW
PLATE
HEX
DRIVE
HUB
FLANGE THICKNESS
ADJUSTMENT KNOB (4X)
INNER
JAW
PLATE
Figure 3b: #AC-##RX
OUTER
JAW
PLATE
501169-001 - Product Manual - AC-R Series Anchor Clamp - Revision 00 - 2012-05-01
INNER
JAW
PLATE
Anchor Clamp
(General Assembly)