Table of Contents
Advertisement
5.1 - Product Description & Capabilities (continued)
Long Side
Orientation
Figure #5c: AC-R Series Anchor Clamp, Testing & Loading Diagram
5.2 - Product Installation & Set-up
Prior to Operation, the AC-R Series Anchor Clamp doe Round Manways must be confi gured and installed according
to the following guidelines.
1. Pre-Operation Inspection:
It is necessary to perform a visual inspection prior to each time
using the product. If any defi ciencies are found, remove the product
from service and contact the T.A. Pelsue Co. regarding repair. The
following checklist coupled with Figure #5.2a should be used as
a guide to determine whether the equipment is in good operating
condition prior to usage. Equipment that is not in good condition
can endanger the safety of the operators during use.
The Pre-Operation Visual Inspection is not limited to, but must
include the following items;
a. Check that the product has no structural defects, such as dents,
bends, cracks, or fractures. Check for elongation of the holes
in the Tower Mounting Ears.
b. Ensure that all product decals are clear and legible.
c. Ensure that the Hex Drive Hub or Speed Handle turns freely
and that the width of the clamp opens and closes as intended
(binding in the width adjustment may be indicative of further
damage).
c. Ensure that the 4X Flange Thickness Adjustment Knobs turn freely and that the jaw plates move up and down as
intended (binding in the adjustment knobs or jaw plates may be indicative of further damage).
501169-001 - Product Manual - AC-R Series Anchor Clamp - Revision 00 - 2012-05-01
90 Degree
Orientation
FLANGE THICKNESS
ADJUSTMENT KNOB
WARNING
DECAL
HEX DRIVE HUB OR
SPEED HANDLE
Pre-Operation Inspection Points
Short Side
Orientation
TOWER MOUNTING
EARS
Figure #5d: AC-R Series
JAW
PLATES
Page 13
Advertisement
Table of Contents
