Disassembly; Assembly - AUTOHELM Masterview ST80 Manual

3. Disassembly

Refer to Figure 1, Exploded View.
1. Unscrew and remove the six No. 2 x 1/2 screws (6). Separate the rear
2. If an ST80 Case Separation Tool is not available, separate the covers
3. When handling the PCB/LCD subassembly, linen or other suitable
4. Unplug the buzzer connector (4) from the PCB (Note: the buzzer is
5. Take the keypad mat (2) out of the front cover.

4. Assembly

Refer to Figure 1, Exploded View.
1. Place the keypad mat (2) into the front cover (1)
2. See notes in Disassembly #2 on handling the PCB/LCD subassembly.
6 Masterview Service Manual 83028_1
cover (5) from the front cover (1) using the ST80 Case Separation Tool
(T041).
by hand. To avoid shattering the case, DO NOT use screwdrivers or
other tools to prise the covers apart. (Note: If they are still attached, it is
helpful to leave the brass mounting studs screwed into the unit rear
cover, or to insert studs if a spare pair are available, to gain a purchase
on the rear cover)
material ( not nylon) gloves should be worn to avoid leaving fingerprints
or other marks on the front label. If gloves are not worn, handle the
subassembly by the edges only. If the label is marked, clean using a
soft static - free cloth only. Do not use solvents or detergents of any
type. Pull the PCB subassembly (3) off the connector pins in the rear
cover. Work round the PCB, lifting each side a little at a time to avoid
distortion of the PCB and solder bucket connectors. Do not attempt to
separate the LCD from the PCB, as it is not possible to re - align and
connect the flexiconnector
glued into the recess in the rear cover and is not removeable)
Plug the buzzer connector (4) into the PCB (3). Position the PCB
subassembly (3) into the rear cover (5), ensuring that the connector
pins in the rear cover line up with the solder buckets on the PCB before
pressing the PCB into place. Work round the edges as much as possi-
ble, pressing gently but firmly so that the subassembly settles into
place a little at a time and the EL panel/LCD surround are not damaged
or distorted
ST80 Masterview