Internal Drive Reset After Battery Change - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
nugget

Internal Drive Reset After Battery Change

Purpose: Defines how the reader operates the Type I PC card drive after you change the
NiCad battery pack. If a PC card is installed when you replace the battery pack,
the reader cannot determine if the PC card has also been replaced. For help, see
"Configuring the Reader to Reset the Type I Drive" in Chapter 4.
There are three options:
Reset card If a PC card is installed, resets the Type I PC card drive every time
you replace the NiCad battery pack.
Do not reset card Does not reset the Type I PC card drive when you replace the
battery pack. If you do change the PC card, you need to reboot the reader.
Prompt for reset If a PC card is installed, prompts you to reset the Type I PC
card drive each time you replace the battery pack.
Default: Do not reset card
Syntax: ESdata
Acceptable values for data are:
0
1
2
Caution
If you set the "Do not reset card" option, you must reboot the reader after
changing a PC card or you may lose data.
Conseil
Si vous réglez l'option "Do not reset card," vous devez réinitialiser le
lecteur après avoir changé une carte PC ou vous risquez de perdre des
données.
12-60
3 9
helconital
Reset card
Do not reset card
Prompt for reset