Controlling The Microphone - Focusrite Audio Engineering vocaster one studio User Manual

VOCASTER HUB SOFTWARE

Controlling the microphone

The Host Input panel is where you adjust
Vocaster One's microphone channel:
The Mic Level display is both a level meter
and a level control. Click and drag the grey
bar to adjust the gain. This control duplicates
the rotary gain knob on the interface, and you
can adjust the gain with either control. The
colour bar shows the microphone signal level,
and again, this duplicates the signal level halo
display on the interface.
focusrite.com
The bar should remain green most of the
time, with amber showing only on the loudest
'peaks'. If it goes red, the gain is set too high.
Below the meter/level display are three
buttons which duplicate those on the
interface top panel:
• Auto Gain – click this to start the
Auto Gain function; speak normally
into the microphone for 10 seconds to
calibrate the gain setting.
• Enhance
– click on this to activate
the Enhance feature; the button shows
green. Click again to deactivate.
• Mute – click on this to mute the
microphone; the button and the level
display show red when mute is active.
Click again to unmute.
Tell the world 23